11.10.2021, 09:50
![[Bild: 27nohlxdypusyfsp0q8kjyrka5.jpg]](https://abload.de/img/27nohlxdypusyfsp0q8kjyrka5.jpg)
The Complete Cisco CCNA & CCNP Networking Labs Course 2022
Genre: eLearning | MP4 | Video: h264, 1280x720 | Audio: AAC, 44.1 KHz
Language: English | Size: 25.3 GB | Duration: 50h 23m
Complete labs guide for Cisco CCNA & CCNP Networking students to setup LAN, EIGRP, OSPF, BGP, Multicast, Python & ASA.
What you'll learn
Configure Vlan & Trunk Port on Switches
Learn to Add/Remove Vlans in Trunking
Configuration of DTP ( Dynamic Trunking Protocol )
Configure Routing on Stick
VTP Configuration on Switches
Understand STP, Root Bridge Election, Root Port and Cost
Understand EtherChannel and It's Modes
Configure Port Security on Switchports
Learn to Setup IP Addresses on Routers and Switches.
Learn to Secure Router Access
Understand Static, Default & Floating Route
Configure RIP - Routing Information Protocol
Configure EIGRP - Enhanced Interior Gateway Routing Protocol
Understand Feasible Condition Lab in EIGRP
Understand EIGRP Timers and Passive Interface
OSPF Configuration on Cisco Routers
Understand OSPF vs EIGRP Vs Static Route Comparison
Understand OSPF DR/BDR Election
Configure Layer 2 Dynamic Switchports
Understand 802.1q Dynamic Trunking & 802.1q Native VLAN
Understand DTP Negotiation
Learn to configure VTP Domain, VTP Transparent, VTP Pruning
Configure VTP Prune Eligible List, Version 3 in VTP
Understand Layer 2 EtherChannel Configuration
Set up Layer 2 EtherChannel using PAgP and LACP
Configure Layer 3 EtherChannel
Understand Root Bridge Election & Root Port Election
Learn to do STP Root Port Selection using Port Priority
Lab of STP Designate Port Selection & Timers in Spanning-Tree
Configure PortFast and Global PortFast in Spanning-Tree
Configure UplinkFast & BackBoneFast in Spanning-Tree
Configure BpduGuard in Spanning-Tree
Learn to Enable BpduGuard Globally in Spanning-Tree
Configure BPDU Filter in Spanning-Tree
Configure Root Guard & Loop Guard in Spanning-Tree
Understand MST Root Bridge Selection
Lean to do MST Path Selection using Cost and Port Priority
Configure UDLD & Protected Ports in LAN Switching
Configure Traffic Storm Control, SPAN and RSPAN
Learn the Quick way to run EIGRP
Configure Static Neighbors, Hello Hold Timers in EIGRP
Understand Metric Calculation and configure Auto/Unequal Load Sharing in EIGRP
Configure Authentication in EIGRP
Understand Auto Summary, Manual Summarization in EIGRP
Learn to configure Maximum Path in EIGRP
Configure Redistribution Between Different AS, EIGRP/OSPF Redistribution
Configure Passive Interfaces, Distribute List, Offset List in EIGRP
Learn to do Basic OSPF Configuration, OSPF Inter Area
Configure Inter Area, Dead Timer Lab in OSPF
Understand Router-ID election in OSPF
Configure Plain and MD5 Authentication in OSPF
Understand Authentication Area vs Interface Level
Understand DR BDR Election, Multicast IPs in OSPF
Understand Metric Calculation, AutoCost Reference Bandwidth in OSPF
Configure Passive Interfaces, Virtual Links in OSPF
Understand External Metric Types E1 and E2 & comparison
Understand OSPF Inter Area Summarization and Summarization of External Subnets in OSPF
Configure Stub Area, Totally Stub Area, NSSA in OSPF
Configure NSSA Stub , NSSA Totally Stubby Area in OSPF
Understand Default Information Originate in OSPF
Understand and Configure IBGP/ EBGP on Cisco Routers
Configure BGP neighborship using Non-Directly-Connected IPs + EBGP Multihop
Learn to Read BGP Table, Advertise Networks in BGP
Configure Next Hop Self, Auto Summary in BGP
Understand BGP Neighbor Adjacency States
Understand BGP Messages using Wireshark
Learn to Troubleshoot BGP Neighorship, Network Advertisement
Understand and Weight, Local Preference, AS-Prepend Attribute in BGP
Understand and configure BGP Origin Code, MED , Communities Attributes
Learn to Configure No-Advertise, No-Export Community in BGP
Configure BGP Prevent Transit AS using Filter List, No-Export Community, Prefix List & Distribution List
Understand and Configure Peer Group, Route Reflector, Confederation in BGP
Understand DHCP, It's Overview and Packet Flow with Wireshark
Learn to configure DHCP Server and Client on Cisco Router
Learn to Exclude IP or IP Range in DHCP server which is configured on Cisco Router
Learn to Modify Client ID on DHCP Client Router, Reserve DHCP IP on Cisco Router
DHCP Relay Agent Configuration, Troubleshooting DHCP on Cisco Router
Understand and Configure Static NAT, Dynamic NAT, PAT (Port Address Translation)
Configure PAT with Multiple Outside Interfaces, NAT Port Forwarding, NAT Troubleshooting
Configure HSRP with Tracking Interfaces and Troubleshoot HSRP
Configure VRRP with Tracking Interfaces
Learn to Configure GLBP (Gateway Load Balancing Protocol)
IPv6 Understanding and Configuring on Cisco Router
Shortening of IPv6 Address, Link-Local Address in IPv6
Learn to change Link-Local Address in IPv6
Understand IPv6 Multicast Groups, Neighbor Discovery in IPv6
Understand Router Advertisement Packets, IPv6 Address AutoConfiguration
Configure Static Routing with IPv6, RIPng ( RIP using IPv6)
Configure OSPFv3, EIGRP with IPv6
Understand Unicast, Broadcast, Multicast and Multicast Components
Description
You are at the right place and at the right time to gain access to videos which cover all important lab topics required for you to pass the CCNA and CCNP exams. This course will raise your ability to configure, design, troubleshoot Problems of IT infrastructure.
This is one of the most popular and Best Selling Courses at Udemy for CCNA and CCNP.
CCNA and CCNP are the MUST certification in IT Industry for Network Administrators and Engineer if you are looking to work in top MNC. CCNA has become a gateway to other networking streams as it explains fundamental concepts clearly. It is a prerequisite to other courses such as CCNP.
You receive full access to all 31+ hours of the course, including downloading - you can download one video or download them all! You'll have permanent online access to watch the videos whenever you like as well, and there's a Q&A forum right here on Udemy where you can post questions - and I'll answer them personally!
I assure you that you will become very good in configuring, implementing routing and switching and troubleshooting the problems post completing this course. This course has in-depth details of the topics. This course will provide you the right knowledge, training, expertise required to work remotely on highly critical network and Servers.
CCNA has become a gateway to other networking streams as it explains fundamental concepts clearly. It is a prerequisite to other courses such as CCNP
This is what people have to say about this course
Amador P. Torrez - Ashish is a very good instructor. Once you get used to his accent it's an enjoyable experience. Personally, it wasn't hard to get used to. I like that he provides labs that can be created in virtual environments such as GNS3 and can be applied to live equipment if provided on your own. I'm thankful that the instructor took the time to create this course which is full of hands on examples that you can retake as many times as you need in order to drill the concepts home. He communicates often and has added labs along the way which is just icing on the cake. I highly recommend this instructor and his courses. 5 STARS!
Farshid Miri - The course is very informative, right on the point, no unnecessary information and entirely a hands-on course.
It is good for someone who would like to learn Cisco networking in action and be capable of DOING rather than just be able to pass Cisco exams! It might be still very useful for Cisco exams, but it might not cover all the details for that matter.
I personally enjoyed this course a lot and I can apply all the knowledge I learned from it in my workplace on a daily basis.
Regarding the language and accent, if the trainee has lived his entire life with one single accent around him in a small town, this course might be a bit challenging to follow, but if one is coming with an international mind-set, he can follow every single line of the course.
The only negative comment could be that the course pace might be very fast for new learners and before each session, a bit of definitions, terminology and concepts could be helpful.
the course starts with a list of tasks and then goes right away to terminal and commands. Good for me, but for new people in Cisco world, it might be a bit challenging to follow.
Overall I recommend this course a lot and will buy more courses from Ashish :-)
Kenel Doantien - I'm impressed with how the teacher is explaining EIGRP in a simple and short way.
Abbe katerega - Personally, no reservation i love the instructor . You make this course so simple and then you give students take to listen to each of your words. I appreciate and HIGHLY recommend other students to join
Daniel Ramsay - The content is right to the point and simple to follow and Lab yourself. Many times we don't spend time testing our troubleshooting abilities. This course, and, the way it's taught allows me strengthen this critical skill.
Mark fruge - Practical knowledge of the subject matter with clear and concise instructions. Being able to simultaneously watch Ashish guide me while I do the labs myself help a ton! Plus, if I'm feeling confident enough to figure something out on my own, I can try in my own lab and then watch the video afterwards should I run into any obstacles.
Tim Pastick - This is a great course which I haven't been able to find anywhere else. Well layed out and easy to understand and follow. IF you work in a large Database Environment I would definitely recommend
Wallace Nelson - Great Video so far. Clear Teacher and instructional videos. I'm really enjoying it. Plus it gets right to the point! Not all the fluff that's some of the other videos have.
Jose Antonio Alejos Bravo - Exelente con GNS3 se entiende todo =) , espero que NEXUS lo haga lo mismo
Adam Foots - It has lot of Labs and every lap has v important Information.
John Elliott -Very clear and precise. Also goes at a good pace. Thanks!!
It has rating of 4.7+ . If you have any question, Always post to me or in forum. I will try to jump on it as soon as possible. In case you are not happy with course- apply for refund with in 30 days time.
Who this course is for:
CCNA , CCNP and Networking Aspirants should apply for this course
Students who want to learn Practical aspects of Routing Protocols should apply for this.
If you need to be knowledgeable in Networking, than this is the course for you!
Homepage
![[Bild: 3.hellodeadtimerlabinlhk0i.jpg]](https://abload.de/img/3.hellodeadtimerlabinlhk0i.jpg)
Download from Rapidgator:
